Safety Warning

DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.

2007 Ford Edge SE, FWDFACTORY OEM SERVICE PROCEDURE

Overdrive/Direct Clutch Assembly: Notes

Special Tools

Illustration	Tool Name	Tool Number
	Compressor, Forward/Overdrive Spring	307-584 (includes 307-584/1 and 307-584/2)
	Compressor, Overdrive Clutch and Balance Piston	307-589 (includes 307-589/1 and 307-589/2)
	Dial Indicator Gauge With Holding Fixture	100-002 (TOOL-4201-C)

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready Tools Compare Repair Quote Quote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.
• Brakes feel soft, pull hard to one side, or make grinding noises.
• The engine overheats, stalls repeatedly, or misfires under load.
• You are missing required tools, torque specs, or safe lifting equipment.
• You are not confident in the next step or safety outcome.