Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, FWDFACTORY OEM SERVICE PROCEDURE
Climate Controlled Seat Module (CCSM)
CLIMATE CONTROLLED SEAT MODULE (CCSM) DIAGNOSTIC TROUBLE CODE (DTC) LIST
| DTC | Description | Retrieved | Perform Test |
|---|---|---|---|
| B103B | Thermoelectric Driver Overcurrent Low | On-Demand and Continuous | Go to Pinpoint Test AG . |
| B103C | Thermoelectric Driver Open Load | On-Demand and Continuous | Go to Pinpoint Test AH . |
| B103D | Blower Driver Overtemperature | On-Demand and Continuous | Go to Pinpoint Test AI . |
| B1111 | Driver Thermoelectric Device Control Overtemperature Fault | On-Demand and Continuous | Go to Pinpoint Test AG . |
| B1113 | Passenger Thermoelectric Device Control Overtemperature Fault | On-Demand and Continuous | Go to Pinpoint Test AJ . |
| B111B | Passenger Thermoelectric Driver Overcurrent Low | On-Demand and Continuous | Go to Pinpoint Test AJ . |
| B111C | Passenger Thermoelectric Driver Open Load | On-Demand and Continuous | Go to Pinpoint Test AK . |
| B111D | Passenger Blower Driver Overtemperature | On-Demand and Continuous | Go to Pinpoint Test AL . |
| B2729 | Cushion Over-Temp Detected (Driver) | On-Demand and Continuous | Go to Pinpoint Test AM . |
| B272A | Passenger Cushion Over-Temp Detected | On-Demand and Continuous | Go to Pinpoint Test AN . |
| B272B | Passenger Back Over-Temp Detected | On-Demand and Continuous | Go to Pinpoint Test AO . |
| B2730 | Back Over-Temp Detected (Driver) | On-Demand and Continuous | Go to Pinpoint Test AR . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.