Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, FWDFACTORY OEM SERVICE PROCEDURE
Engine Mount: Notes
Special Tools
| Illustration | Tool Name | Tool Number |
|---|---|---|
| Oil Pan Holding Fixture | 303-1295 |
| Item | Part Number | Description |
|---|---|---|
| 1 | W807658 | Degas bottle-to-fender bolt (2 required) |
| 2 | W709603 | Degas bottle-to-washer bottle bolt |
| 3 | 8A080 | Degas bottle |
| 4 | W520102 | Engine mount brace nut |
| 5 | 6K075 | Engine mount brace |
| 6 | W712334 | Engine mount-to-engine nut (4 required) |
| 7 | W712511 | Engine mount brace bolt |
| 8 | W712507 | Engine mount-to-frame bolt (3 required) |
| 9 | 6F012 | Engine mount |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.