Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge SE, FWDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| ABS module screws | 5 | - | 44 |
| Brake caliper brake tube-to-hydraulic control unit (HCU) fittings | 22 | 16 | - |
| HCU bracket-to-frame bolts | 25 | 18 | - |
| HCU bracket-to-HCU bolt | 15 | 11 | - |
| Master cylinder brake tube-to-HCU fittings | 27 | 20 | - |
| Stability control sensor cluster nuts | 9 | - | 80 |
| Steering wheel rotation sensor bolts | 1 | - | 9 |
| Wheel speed sensor bolts | 7 | - | 62 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.