2007 Ford Edge FWD V6-3.5LFACTORY OEM SERVICE PROCEDURE

Power Window Switch: Service and Repair

WINDOW CONTROL SWITCH

Removal and Installation

Edge only
1. Pull the switch bezel straight up to unclip it from the door trim panel.

MKX only


Factory service manual diagram





2. NOTE: LH front shown, all others similar.

Pull up on the front edge of the switch bezel and pull forward to unhook it from the door trim panel.

All vehicles
3. Disconnect the electrical connector(s).
4. Unclip the window control switch from the switch bezel.
5. To install, reverse the removal procedure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.