Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge FWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Piston Ring, Engine
Piston Rings
Ring end gap
Compression (top, gauge diameter) 0.15-0.25 mm (0.0059-0.0098 inch)
Compression (bottom, gauge diameter) 0.30-0.55 mm (0.0118-0.0216 inch)
Oil ring (steel rail, gauge diameter) 0.15-0.45 mm (0.0059-0.0177 inch)
Ring groove width
Compression (top) 1.230-1.25 mm (0.0484-0.0492 inch)
Compression (bottom) 1.530-1.55 mm (0.0602-0.0610 inch)
Oil ring 2.53-2.55 mm (0.0996-0.1003 inch)
Ring width
Upper comp ring 1.17-1.19 mm (0.0460-0.0468 inch)
Lower comp ring 1.47-1.49 mm (0.0578-0.0586 inch)
Ring-to-groove clearance (upper and lower compression rings) 0.040-0.080 mm (0.0015-0.0031 inch)
Ring end gap
Compression (top, gauge diameter) 0.15-0.25 mm (0.0059-0.0098 inch)
Compression (bottom, gauge diameter) 0.30-0.55 mm (0.0118-0.0216 inch)
Oil ring (steel rail, gauge diameter) 0.15-0.45 mm (0.0059-0.0177 inch)
Ring groove width
Compression (top) 1.230-1.25 mm (0.0484-0.0492 inch)
Compression (bottom) 1.530-1.55 mm (0.0602-0.0610 inch)
Oil ring 2.53-2.55 mm (0.0996-0.1003 inch)
Ring width
Upper comp ring 1.17-1.19 mm (0.0460-0.0468 inch)
Lower comp ring 1.47-1.49 mm (0.0578-0.0586 inch)
Ring-to-groove clearance (upper and lower compression rings) 0.040-0.080 mm (0.0015-0.0031 inch)
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.