Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge FWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Body Control Module: Service and Repair
DRIVER SEAT MODULE (DSM)
Special Tool(s)
Removal and Installation
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new module after installation.
1. NOTE: This step is necessary only if the DSM is being replaced.
Upload the module configuration information from the DSM into the scan tool.
2. NOTE: If the driver seat can be moved to a high enough position, the DSM screws can be removed without removing the driver seat.
If necessary, remove the driver seat.
3. Remove the 2 screws.
4. Disconnect the 4 electrical connectors and remove the DSM.
5. NOTE: Make sure to download the DSM configuration information from the scan tool into the new DSM.
To install, reverse the removal procedure.
Special Tool(s):
Special Tool(s)
Removal and Installation
CAUTION: Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
NOTE: Prior to the replacement of the module, it is necessary to upload the module configuration information to the appropriate scan tool. This information must be downloaded into the new module after installation.
1. NOTE: This step is necessary only if the DSM is being replaced.
Upload the module configuration information from the DSM into the scan tool.
2. NOTE: If the driver seat can be moved to a high enough position, the DSM screws can be removed without removing the driver seat.
If necessary, remove the driver seat.
3. Remove the 2 screws.
4. Disconnect the 4 electrical connectors and remove the DSM.
5. NOTE: Make sure to download the DSM configuration information from the scan tool into the new DSM.
To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.