Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2007 Ford Edge FWD V6-3.5LFACTORY OEM SERVICE PROCEDURE
Rear
HEATED SEAT MODULE - REAR SEAT
Removal and Installation
1. Remove the second row 60 percent seat front riser-to-floor nut and bolt.
- To install, tighten to 70 Nm (52 lb-ft).
2. Pivot the front of the 60 percent seat cushion upward.
3. Remove the screw, disconnect the electrical connector and remove the heated seat module.
4. To install, reverse the removal procedure.
Removal and Installation
1. Remove the second row 60 percent seat front riser-to-floor nut and bolt.
- To install, tighten to 70 Nm (52 lb-ft).
2. Pivot the front of the 60 percent seat cushion upward.
3. Remove the screw, disconnect the electrical connector and remove the heated seat module.
4. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.