2007 Ford Cutaway 6.0 PFACTORY OEM SERVICE PROCEDURE

Module Communications Network DTCS

COMMUNICATION NETWORK DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Perform Test
U0002 High Speed CAN Communication Bus Performance Instrument cluster The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0011 Medium Speed CAN Communication Bus Performance Instrument cluster The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0073 Control Module Communication Bus Off Anti-lock brake system (ABS) module The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0073 Control Module Communication Bus Off Vehicle security module (VSM) The module could not communicate on the network at a point in time. The fault is currently not present. CLEAR the DTC. REPEAT the network test with the scan tool.
U0155 Lost Communication With Instrument Panel Cluster (IC) Control Module VSM If the instrument cluster failed the network test, go to Pinpoint Test C . Otherwise, REFER to INSTRUMENT CLUSTER article.
U1900 CAN Communication Bus Fault-Receive Error ABS module Go to for module that failed network test.
U1900 CAN Communication Bus Fault-Receive Error Instrument cluster Go to for module that failed network test.
U1901 CAN Network #2 Communication Bus Fault - Receive Error ABS module REFER to VEHICLE DYNAMIC SYSTEMS article.
U2023 Fault Received From External Node Instrument cluster U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs.
U2023 Fault Received From External Node VSM U2023 is set when a module receives invalid network data from another module with a faulted input. RETRIEVE and REPAIR all non-network DTCs in the other modules on the network. REFER to MULTIFUNCTION ELECTRONIC MODULES article for a list of all DTCs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.