Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Ford Taurus SE, 3.0 2FACTORY OEM SERVICE PROCEDURE
General Specifications
GENERAL SPECIFICATIONS
| Item | Specification |
|---|---|
| Base ignition timing (not adjustable) | 10 degrees BTDC |
| Firing order | 1-4-2-5-3-6 |
| Spark plug gap | 1.07-1.17 mm (0.042-0.046 in) |
| Original spark plug (gasoline engine) | AGSF32PM and PGM |
| Original spark plug (flex fuel engine) | AGSF22PM/PGM |
| Service spark plug (gasoline engine) | AGSF-32FM |
| Service spark plug (flex fuel engine) | AGSF-22FM |
| Silicone Brake Caliper Grease and Dielectric Compound XG-3-A | ESE-M1C171-A |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
