2006 Ford Taurus SE, 3.0 2FACTORY OEM SERVICE PROCEDURE

Pinpoint Test B: High Engine Idle Speed

  1. B1 CHECK THE CABLE CONDITION 
    • Disconnect the accelerator cable from the cam at the throttle body.
    • Make sure the disconnected end of the accelerator cable does not come in contact with any of the surrounding parts.
    • Is the cable core wire kinked, frayed or damaged? 

    Yes  : INSTALL a new accelerator cable. REFER to ACCELERATOR CABLE .

    No  : GO to  B2.

  2. B2 RESTRICTED CABLE MOVEMENT 
    • With the cable disconnected from the cam at the throttle body, pull the core wire through its entire travel from the pedal end and then from the throttle end.
    • Is the cable movement rough, sticky or restricted? 

    Yes  : INSTALL a new accelerator cable. REFER to ACCELERATOR CABLE .

    No  : GO to  B3.

  3. B3 RESTRICTED THROTTLE BODY LEVER MOVEMENT 
    • Disconnect the speed control actuator cable from the throttle body lever.
    • Cycle the throttle body lever through its entire range of movement.
    • Is the throttle body lever movement rough, sticky or restricted? 

    Yes  : REFER to the INTRODUCTION - GASOLINE for diagnosis and testing of the throttle body

    No  : REFER to SPEED CONTROL.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.