Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Ford Freestar BaseFACTORY OEM SERVICE PROCEDURE
Torque Converter
- A new or remanufactured torque converter must be installed if one or more of the following statements is true:
- A torque converter malfunction has been determined based on complete diagnostic procedures.
- Converter stud or studs, impeller hub or bushing are damaged.
- Discoloration (due to overheating).
- Evidence of transmission assembly or fluid contamination due to the following transmission or converter failure modes:
- Major metallic failure.
- Multiple clutches or clutch plate failures.
- Sufficient component wear which results in metallic contamination.
- Internal torque converter contamination present. For additional information, refer to TORQUE CONVERTER CONTAMINATION INSPECTION in this article.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.