2006 Ford Freestar BaseFACTORY OEM SERVICE PROCEDURE

Audio Unit

AUDIO UNIT DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Perform Test
B1342 ECU is Defective DOCUMENT and CLEAR the DTCs. CARRY OUT the Audio Unit On-Demand Self-Test. If DTC B1342 is retrieved again, REMOVE the audio unit and SEND it to an authorized audio system repair facility. REFER to AUDIO UNIT in this article. TEST the system for normal operation after the repair.
B2103 Antenna Not Connected GO to PINPOINT TEST B .
B2401 Audio Tape Deck Mechanism Fault Not applicable for CDX6. DOCUMENT and CLEAR the DTCs. CARRY OUT the Audio Unit On-Demand Self-Test. If DTC B2401 is retrieved again, REMOVE the audio unit and SEND it to an authorized audio system repair facility. REFER to AUDIO UNIT in this article. TEST the system for normal operation after the repair.
B2404 Audio Steering Wheel Switch Circuit Fault GO to PINPOINT TEST D .
B2405 Audio Single-Disc CD Player Thermal Shutdown Fault Not applicable for CDX6. DOCUMENT and CLEAR the DTCs. CARRY OUT the Audio Unit On-Demand Self-Test. If DTC B2405 is retrieved again, REMOVE the audio unit and SEND it to an authorized audio system repair facility. REFER to AUDIO UNIT in this article. TEST the system for normal operation after the repair.
B2406 Audio Single-Disc CD Player Internal Fault Not applicable for CDX6. DOCUMENT and CLEAR the DTCs. CARRY OUT the Audio Unit On-Demand Self-Test. If DTC B2406 is retrieved again, REMOVE the audio unit and SEND it to an authorized audio system repair facility. REFER to AUDIO UNIT in this article. TEST the system for normal operation after the repair.
B2477 Module Configuration Fault REFER to MODULE CONFIGURATION .
B2913 Subwoofer Not Connected Not applicable.
U2008 Audio Phone is Not Responding Not applicable.
U2014 Audio Subwoofer Unit is Not Responding Not applicable.
U2020 Center Image Amplifier is Not Responding Not applicable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.