Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Ford Freestar BaseFACTORY OEM SERVICE PROCEDURE
Removal and Installation
CAUTION:
During engine repair procedures, cleanliness is extremely important. Any foreign material, including any material created while cleaning gasket surfaces, that enters the oil passages, coolant passages or the oil pan, can cause engine failure.
- Rotate the crankshaft until the piston is at the top of its stroke with both the intake and exhaust valves closed prior to removing the rocker arm.
- Remove the rocker arms. For additional information, refer to VALVE TRAIN COMPONENTS - EXPLODED VIEW and ROCKER ARM in this article.
- Remove the spark plugs. For additional information, refer to ENGINE IGNITION .
- Hold the valve in the cylinder head.
- Apply a minimum of 689 kPa (100 psi) of compressed air into the cylinder.
- Using the special tool, compress the valve springs.
- Remove the following:
- Valve spring retainer key
- Valve spring retainer
- Valve spring
- Valve stem seal
- Inspect the components. For additional information, refer to ENGINE SYSTEM-GENERAL INFORMATION .
- To install, reverse the removal procedure.
CAUTION:
If a valve drops into the cylinder, remove the cylinder head. For additional information, refer to CYLINDER HEAD - LH or CYLINDER HEAD - RH in this article.
CAUTION:
If the components are to be reinstalled, they must be installed in the same position. Mark the components for location.
CAUTION:
Do not release the compressed air from the cylinder until after the valve spring keys are installed.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
