2006 Ford Focus ZXW SES, AutomaticFACTORY OEM SERVICE PROCEDURE

Selector Lever: Assembly

CAUTION: When installing the selector lever knob, make sure the wiring harness is positioned forward and is centered on the shift lever shaft, or damage to the shift lever or wiring harness will occur.
  1. To assemble, reverse the disassembly procedure.
    • Coat all sliding and turning parts with grease.
    • Install a new selector lever knob screw.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.