Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Ford Focus ZX4 STFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in | ||
|---|---|---|---|---|---|
| Camshaft position (CMP) sensor | 20 | 15 | - | ||
| Catalyst monitor sensor(s) (CMS) | 48 | 35 | - | ||
| Crankshaft position (CKP) sensor(1) | - | - | - | ||
| Cylinder head temperature (CHT) sensor | 12 | 9 | - | ||
| Exhaust manifold heat shield bolts | 11 | 8 | - | ||
| Fuel rail pressure and temperature sensor | 5 | - | 44 | ||
| Heated oxygen sensor (HO2S) | 48 | 35 | - | ||
| Idle air control (IAC) valve | 4 | - | 35 | ||
| Knock sensor (KS) | 20 | 15 | - | ||
| Power steering pressure (PSP) switch | 20 | 15 | - | ||
| Throttle position (TP) sensor mounting bolts | 10 | - | 89 | ||
| Generic electronic module (GEM) | 10 | - | 89 | ||
| Mass airflow (MAF) sensor retaining screw | 10 | - | 89 | ||
| Engine plug bolt | 20 | 15 | - | ||
|
|||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.