2006 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE

Supplemental Restraint System

RESTRAINTS CONTROL MODULE (RCM) DIAGNOSTIC TROUBLE CODE (DTC) TABLE

DTC Description Perform Test
- The Air Bag Indicator is Illuminated Continuously, RCM Disconnected or Inoperative, Loss of Battery Feed, or Loss of Signal Ground GO to PINPOINT TEST A .
B1342 RCM Is Faulted Install a new RCM.
B1869 Lamp Air Bag Warning Indicator Circuit Open or Short to Ground GO to PINPOINT TEST B .
B1870 Air Bag Warning Indicator Circuit Short to Battery GO to PINPOINT TEST C .
B1891 Air Bag Tone Warning Indicator Circuit Short to Battery GO to PINPOINT TEST D .
B1892 Air Bag Tone Warning Indicator Circuit Open or Shorted to Ground GO to PINPOINT TEST E .
B1921 Air Bag Diagnostic Monitor Ground Circuit Open GO to PINPOINT TEST F .
B2292 Restraint System - Safety Belt Pretensioner Status (Driver Pretensioner Circuit Fault) GO to PINPOINT TEST G .
B2292 Restraint System - Safety Belt Pretensioner Status (Passenger Pretensioner Circuit Fault) GO to PINPOINT TEST G .
B2293 Restraint System - Air Bag Status (Driver Front Air Bag Circuit Fault) GO to PINPOINT TEST P .
B2293 Restraint System - Air Bag Status (Passenger Front Air Bag Circuit Fault) GO to PINPOINT TEST H .
B2294 Restraint System - Safety Canopy Module Status (Driver Side Safety Canopy Circuit Fault) GO to PINPOINT TEST I .
B2294 Restraint System - Safety Canopy Module Status (Passenger Side Safety Canopy Circuit Fault) GO to PINPOINT TEST I .
B2296 Restraint System - Impact Sensor Status (Front Impact Severity Sensor Circuit Fault) GO to PINPOINT TEST J .
B2296 Restraint System - Impact Sensor Status (Driver Side Front Row Impact Sensor Circuit Fault) GO to PINPOINT TEST J .
B2296 Restraint System - Impact Sensor Status (Driver Side Second Row Impact Sensor Circuit Fault) GO to PINPOINT TEST J .
B2296 Restraint System - Impact Sensor Status (Passenger Side Front Row Impact Sensor Circuit Fault) GO to PINPOINT TEST J .
B2296 Restraint System - Impact Sensor Status (Passenger Side Second Row Impact Sensor Circuit Fault) GO to PINPOINT TEST J .
B2691 Driver Safety Belt Buckle Switch Circuit Fault GO to PINPOINT TEST K .
B2434 Driver Safety Belt Buckle Switch Circuit Short to Ground GO to PINPOINT TEST L .
B2435 Driver Safety Belt Buckle Switch Circuit Resistance Out of Range GO to PINPOINT TEST M .
B2692 Passenger Safety Belt Buckle Switch Circuit Fault GO to PINPOINT TEST N .
B2438 Passenger Safety Belt Buckle Switch Circuit Short to Ground GO to PINPOINT TEST O .
B2439 Passenger Safety Belt Buckle Switch Circuit Resistance Out of Range GO to PINPOINT TEST P .
B2477 Module Configuration Error INSTALL a new RCM.
C1414 Incorrect Vehicle ID GO to PINPOINT TEST Q .
C1947 Seat Track Position Sensor Circuit Short to Ground GO to PINPOINT TEST R .
C1948 Seat Track Position Sensor Circuit Resistance Out of Range GO to PINPOINT TEST S .
C1981 Seat Track Position Sensor Circuit Fault GO to PINPOINT TEST T .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.