Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE
Key Programming Switch State Control: Notes
SPECIAL TOOLS REFERENCE
| Worldwide Diagnostic System (WDS) Vehicle Communication Module (VCM) with appropriate adapters, or equivalent diagnostic tool |
NOTE:
- The spare key programming switch is a diagnostic tool programmable switch which provides the capability to enable/disable the customer spare key programming procedure. This procedure is in the Owner's Literature spare key programming procedure or under Key Programming Using Two Programmed KeysΒ . This programmable switch is provided as a convenience for customers who may not want the spare key programming procedure available to the vehicle driver.
- The spare key programming switch state can be viewed by PCM PID SPARE_KY.
- Insert a programmed ignition key into the ignition lock cylinder and turn the ignition switch to RUN.
- Using the diagnostic tool Ford service function (FSF) card, select PCM from the menu. Follow SECURITY ACCESS to obtain security access. For additional information, refer to ANTI-THEFT SECURITY ACCESSΒ .
- From the diagnostic tool menu, select SPARE KEY PROGRAMMING SWITCH selection to desired setting:
< ENABLE > spare key programming procedure is accessible.
< DISABLE > spare key programming procedure is not accessible.
NOTE:
The default setting on delivery of all new vehicles is < ENABLE >.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
