Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Ford Expedition 4WDFACTORY OEM SERVICE PROCEDURE
Component Testing Procedure
WARNING: This page is about a different car, the 2005 Lincoln Navigator and 2005 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
MASTER WINDOW ADJUST SWITCH - COMPONENT TESTING - EXPEDITION
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good swtich will indicate |
|---|---|---|---|
| Power and Ground Checks Before Any Other Tests | 8 and 7, C504b | Window lockout Off | Closed circuit |
| 5, C504b and 1, 2, 3, 4, 5, 6, 7, 8 C504a | Rest | ||
| 8, C504b and 1, 2, 3, 4, 5, 6, 7, 8 C504a | Rest | Open circuit | |
| Driver front window circuit | 8, C504b and 5, C504a | Up | Closed circuit |
| 6, C504a and 5, C504b | |||
| 8, C504b and 6, C504a | Down | ||
| 5, C504a, and 5, C504b | |||
| Up | 800ohm--1000ohm | ||
| one-touch down | 5, C504b and 8, C504b | Rest | 800ohm--1000ohm |
| Passenger front window circuit | 8, C504b and 7, C504a | Up | Closed circuit |
| 8, C504a, and 5, C504b | |||
| 8, C504b and 8, C504a | Down | ||
| 7, C504a, and 5, C504b | |||
| Left rear window circuit | 8, C504b and 2, C504a | Up | Closed circuit |
| 1, C504a and 5, C504b | |||
| 8, C504b and 1, C504a | Down | ||
| 2, C504a and 5, C504b | |||
| Right rear window circuit | 8, C504b and 3, C504a | Up | Closed circuit |
| 4, C504a and 5, C405b | |||
| 8, C504b and 4, C504a | Down | ||
| 3, C504a and 5, C504b | |||
| Illumination | Connect pin 8, C504b to 12V DC power and pin 5, C504b to ground. | Visually inspect switch to verify illumination. | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
