2006 Ford Expedition 4WDFACTORY OEM SERVICE PROCEDURE

Component Testing Procedure

WARNING: This page is about a different car, the 2005 Lincoln Navigator and 2005 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
ADJUSTABLE PEDAL SWITCH - COMPONENT TESTING (WITH MEMORY)

Circuit to test Connect self-powered test light or ohmmeter to terminals Move switch to these positions A good switch will indicate
Forward/rearward circuit 1 and 2, C2089 Forward Closed circuit
7 and 4, C2235 Rest Open circuit
Rearward
7 and 2, C2089 Forward Open circuit
3 and 4, C2235 Rest
Rearward Closed circuit
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.