Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2006 Ford Expedition 4WDFACTORY OEM SERVICE PROCEDURE
Section 146 (Electronic Engine Control System)
WARNING: This page is about a different car, the 2005 Lincoln Navigator and 2005 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
- Specifications
- Description And Operation
- Diagnosis And Testing
- Removal And Installation
- Variable Camshaft Timing (VCT) Oil Control Solenoid
- Fuel Rail Pressure and Temperature Sensor
- Camshaft Position (CMP) Sensor
- Crankshaft Position (CKP) Sensor
- Powertrain Control Module (PCM)
- Throttle Position (TP) Sensor
- Mass Air Flow (MAF) Sensor
- Knock Sensor (KS)
- Cylinder Head Temperature (CHT) Sensor
- Charge Motion Control Valve (CMCV)
- Heated Oxygen Sensor (HO2S) and Catalyst Monitor Sensor - Exploded View
- Heated Oxygen Sensor (HO2S)
- Catalyst Monitor Sensor
- Oil Temperature Sensor
- Engine Oil Pressure (EOP) Sensor
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
