Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Ford Mustang Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Camshaft position (CMP) sensor bolt - 4.0L | 6 | - | 53 |
| CMP sensor bolt - 4.6L | 10 | - | 89 |
| A/C compressor stud bolts- 4.6L | 25 | 18 | - |
| Crankshaft position (CKP) sensor bolts | 10 | - | 89 |
| Cylinder head temperature (CHT) sensor - 4.6L | 10 | - | 89 |
| Throttle position (TP) sensor screws | 3 | - | 27 |
| Mass airflow (MAF) sensor screws | 2 | - | 18 |
| Heated oxygen sensors (HO2S) | 48 | 35 | - |
| Catalyst monitor sensors (CMS) | 48 | 35 | - |
| Fuel rail pressure and temperature sensor bolts | 6 | - | 53 |
| Knock sensor (KS) bolts | 20 | 15 | - |
| Oil pan drain plug - 4.6L | 14 | 10 | - |
| Oil temperature sensor - 4.6L | 15 | 11 | - |
| Powertrain control module (PCM) bolts | 8 | - | 71 |
| Variable camshaft timing (VCT) solenoid - 4.6L | 5 | - | 44 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.