Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Component Testing Procedure
2005 Ford GTSECTION Component Testing Procedure
WARNING: This page is about a different car, the 2006 Ford F550 Super Duty, 2006 Ford F450 Super Duty, and 2006 Ford Cab & Chassis. However, it is still accessible from the selected car via links, so may be relevant.
MULTIFUNCTION SWITCH, LAMP PORTION COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| High beam | 8 and 7 | High beam | Closed circuit |
| Flash-to-pass | Open circuit | ||
| Low beam | Open circuit | ||
| Low beam/Flash-to-pass | 8 and 9 | High beam | Open circuit |
| Flash-to-pass | Closed circuit | ||
| Law beam | Closed circuit | ||
| 6 and 7 | High beam | Open circuit | |
| Flash-to-pass | Closed circuit | ||
| Low beam | Open circuit |
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.