Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Ford Freestar BaseFACTORY OEM SERVICE PROCEDURE
Main Control - Pump: Removal
- With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to JACKING & LIFTING .
- Remove the battery tray. For additional information, refer to BATTERY, MOUNTING AND CABLES .
- Loosen the clamps and remove the air cleaner tube.
- Remove the air cleaner assembly. For additional information, refer to INTAKE AIR DISTRIBUTION & FILTERING .
- Disconnect the electrical connectors.
- Disconnect the digital transmission range (TR) sensor electrical connector.
- Disconnect the transaxle electrical connector.
- Disconnect the speed control electrical connector.
- Remove the wiper arm and pivot assembly. For additional information, refer to WIPERS AND WASHERS .
- Remove the passenger compartment air intake box.
- Remove the air intake tube.
- Remove the front upper radiator shield.
- Remove the hood latch and position aside.
- Remove the oil filler cap.
- Install the special tool (front of engine compartment).
- Install the special tool (rear of engine compartment).
- Install the special tools.
- Remove the upper main control cover bolts.
- Remove the rear transaxle support insulator bolt, nut and support insulator.
- Remove the rear transaxle support insulator bracket.
- Remove the remaining bolts, and the main control cover.
NOTE:
When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive shift strategy.
CAUTION:
Do not pull on the wires or the electrical connectors. Damage to the connectors will result.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
