2005 Ford Freestar BaseFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Inner tie-rod 100 74 -
Intermediate shaft-to-steering gear bolt 30 22 Β 
Lower reservoir isolator bolt 10 - 89
Power steering fluid cooler bolts 8 - 71
Power steering pressure line fitting 36 27 -
Power steering pressure line retaining bolt 8 - 71
Power steering pressure line-to-pump fitting 65 48 -
Power steering pump bolts 25 18 -
Power steering return line fitting 36 27 -
Power steering return line retaining bolts 6 - 53
Stabilizer bar link nuts 90 66 -
Steering gear-to-crossmember nuts 175 129 Β 
Tie-rod end jam nuts 55 41 -
Tie-rod end nuts 80 59 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.