2005 Ford Freestar BaseFACTORY OEM SERVICE PROCEDURE

Exterior Lighting: Headlamps

DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Perform Test
B1342 ECU is Defective SJB CLEAR the DTCs. RETRIEVE the DTCs. If DTC B1342 is retrieved, INSTALL a new SJB. REFER to MULTIFUNCTION ELECTRONIC MODULES .
B2501 LF Low Beam Circuit Failure SJB If the low beam is inoperative, GO to PINPOINT TEST B .
If the low beam is always on, GO to PINPOINT TEST B , PINPOINT TEST C .
B2503 RF Low Beam Circuit Failure SJB If the low beam is inoperative, GO to PINPOINT TEST B .
If the low beam is always on, GO to PINPOINT TEST BPINPOINT TEST C .
B2586 Headlamp Mode Select Circuit Failure SJB GO to PINPOINT TEST A .
B2598 Headlamp Relay Circuit Failure SJB If the high beams are inoperative, GO to PINPOINT TEST A .
If the high beams are always on, GO to PINPOINT TEST BPINPOINT TEST C .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.