2005 Ford Freestar BaseFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft lb-in
Camshaft position (CMP) sensor bolts 3 - 27
Camshaft synchronizer bolt 25 18 -
Coolant pump outlet tube bolts 10 - 89
Power steering pump bolts 25 18 -
Crankshaft position (CKP) sensor bolt 7 - 62
Power steering position (PSP) switch 17 13 -
Powertrain control module (PCM) harness electrical connector bolt 7 - 62
PCM-to-dash nuts 5 - 44
Throttle position (TP) sensor-to-throttle body bolts 7 - 62
Idle air control (IAC) valve-to-upper intake manifold bolts 11 8 -
Mass air flow (MAF) sensor screws 10 - 89
Heated oxygen sensors (HO2S) 46 34 -
Catalyst monitor sensors 46 34 -
Cylinder head temperature (CHT) sensor 12 9 -
Fuel pressure and temperature sensor bolts 5 - 44
Intake manifold runner control (IMRC) valve-to-lower intake bolts 10 - 89
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.