2005 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE

Four-Wheel Drive Systems DTCS

4X4 MODULE (PCM) DIAGNOSTIC TROUBLE CODE (DTC) LIST

DTC Description Source Perform Test
C1728 Transfer Case Unable to Transition Between 2WD HIGH and 4WD HIGH 4x4 Module (PCM) GO to PINPOINT TEST C .
C1729 Transfer Case Unable to Transition Between 4WD HIGH and 4WD LOW 4x4 Module (PCM) GO to PINPOINT TEST D .
C1979 IWE Solenoid Circuit Failure 4x4 Module (PCM) GO to PINPOINT TEST B .
C1980 IWE Solenoid Circuit Short to Battery 4x4 Module (PCM) Go to PINPOINT TEST B .
P1812 Transmission 4-Wheel Drive Mode Select Circuit Failure 4x4 Module (PCM) Go to PINPOINT TEST C .
P1815 Transmission 4-Wheel Drive Mode Select Short Circuit to Ground 4x4 Module (PCM) Go to PINPOINT TEST C .
P1820 Transfer Case Clockwise Shift Relay Coil Circuit Failure 4x4 Module (PCM) Go to PINPOINT TEST C .
P1822 Transfer Case Clockwise Shift Relay Coil Short Circuit To Battery 4x4 Module (PCM) Go to PINPOINT TEST C .
P1824 Transmission 4-Wheel Drive Clutch Relay Circuit Failure 4x4 Module (PCM) GO to PINPOINT TEST E .
P1826 Transmission 4-Wheel Drive Low Clutch Relay Short Circuit to Battery 4x4 Module (PCM) Go to PINPOINT TEST E .
P1827 Transmission 4-Wheel Drive Low Clutch Relay Short Circuit to Ground 4x4 Module (PCM) Go to PINPOINT TEST E .
P1828 Transfer Case Counterclockwise Shift Relay Coil Circuit Failure 4x4 Module (PCM) Go to PINPOINT TEST C .
P1830 Transfer Case Counterclockwise Shift Relay Coil Short Circuit To Battery 4x4 Module (PCM) Go to PINPOINT TEST C .
P1849 Transmission Transfer Case Contact Plate A Short Circuit to Ground 4x4 Module (PCM) Go to PINPOINT TEST C .
P1853 Transmission Transfer Case Contact Plate B Short Circuit to Ground 4x4 Module (PCM) Go to PINPOINT TEST C .
P1857 Transmission Transfer Case Contact Plate C Short Circuit to Ground 4x4 Module (PCM) Go to PINPOINT TEST C .
P1861 Transmission Transfer Case Contact Plate D Short Circuit to Ground 4x4 Module (PCM) Go to PINPOINT TEST C .
P1867 Transmission Transfer Case Contact Plate General Circuit Failure 4x4 Module (PCM) Go to PINPOINT TEST C .
P1891 Transmission Transfer Case Contact Plate Ground Return Open Circuit 4x4 Module (PCM) Go to PINPOINT TEST C .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.