2005 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE

Air Suspension Control Module

WARNING: This page is about a different car, the 2006 Lincoln Navigator and 2006 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.

The air suspension control module uses the medium speed CAN. The air suspension control module controls the air compressor motor (through a solid state relay) and all system solenoids. The module also provides power to front and rear height sensors on 4-wheel air suspension systems, or rear height sensors on the rear-wheel suspension systems. The module controls vehicle height adjustments by monitoring 2 height sensors, vehicle speed, a steering sensor, acceleration input, the door ajar signal, transfer case signals and the brake switch. The module also conducts all fail-safe and diagnostic strategies and contains self-test and communication software for testing the vehicle and module. For additional information, refer to VEHICLE DYNAMIC SUSPENSION .

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.