2005 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE

Component Testing Procedure

WARNING: This page is about a different car, the 2006 Lincoln Navigator and 2006 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
WINDOW ADJUST SWITCH COMPONENT TESTING (NAVIGATOR)

Circuit to test Connect self-powered test light or ohmmeter to terminals Move switch to these positions A good switch will indicate
Left rear window circuit, Right rear window circuit  2 and 3 Up Closed circuit
Rest
Down Open circuit
3 and 4 Up Open circuit
Rest
Down Closed circuit
4 and 7 Up Closed circuit
Rest Open circuit
Down
7 and 8 Up Open circuit
Rest Closed circuit
Down
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.