Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE
Component Testing Procedure
WARNING: This page is about a different car, the 2006 Lincoln Navigator and 2006 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
MULTIFUNCTION SWITCH, WIPER/WASHER PORTION COMPONENT TESTING
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Front washer switch circuit | 4 and 6 | Front washer | Closed circuit |
| Off | Open circuit | ||
| Rear washer switch | 4 and 8 | Rear washer | Closed circuit |
| Off | Open circuit | ||
| Front wiper switch circuit | 4 and 1 | Off | Open circuit |
| Low | Closed circuit | ||
| High | |||
| 4 and 5 | Off | Open circuit | |
| Low | Closed circuit | ||
| High | |||
| 4 and 7 | Off | Open circuit | |
| Low | Closed circuit | ||
| High | |||
| Rear wiper switch circuit | 4 and 8 | Off | Open circuit |
| On | Closed circuit | ||
| 4 and 2 | Off | Open circuit | |
| On | Closed circuit | ||
| Intermittent wiper circuit front | 4 and 1 | Intermittent 1 | Closed circuit |
| Intermittent 2 | |||
| Intermittent 3 | Open circuit | ||
| Intermittent 4 | |||
| Intermittent 5 | |||
| 4 and 3 | Intermittent 1 | Open circuit | |
| Intermittent 2 | Closed circuit | ||
| Intermittent 3 | |||
| Intermittent 4 | |||
| Intermittent 5 | Open circuit | ||
| 4 and 7 | Intermittent 1 | Open circuit | |
| Intermittent 2 | |||
| Intermittent 3 | |||
| Intermittent 4 | Closed circuit | ||
| Intermittent 5 | |||
| Intermittent wiper circuit, rear | 4 and 8 | Intermittent | Open circuit |
| 4 and 2 | Intermittent | Closed circuit |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
