Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE
Component Testing Procedure
WARNING: This page is about a different car, the 2006 Lincoln Navigator and 2006 Ford Expedition. However, it is still accessible from the selected car via links, so may be relevant.
MASTER WINDOW ADJUST SWITCH COMPONENT TESTING (EXPEDITION)
| Circuit to test | Connect self-powered test light or ohmmeter to terminals | Move switch to these positions | A good switch will indicate |
|---|---|---|---|
| Power and Ground Checks Before Any Other Tests | 8 and 7, C504b | Window lockout Off | Closed circuit |
| 5, C504b and 1, 2, 3, 4, 5, 6, 7, 8 C504a | Rest | ||
| 8, C504b and 1, 2, 3, 4, 5, 6, 7, 8 C504a | Rest | Open circuit | |
| Driver front window circuit | 8, C504b and 5, C504a | Up | Closed circuit |
| 6, C504a and 5, C504b | |||
| 8, C504b and 6, C504a | Down | ||
| 5, C504a, and 5, C504b | |||
| Up | 800Ω - 1000Ω | ||
| one-touch down | 5, C504b and 8, C504b | Rest | 800Ω - 1000Ω |
| Passenger front window circuit | 8, C504b and 7, C504a | Up | Closed circuit |
| 8, C504a, and 5, C504b | |||
| 8, C504b and 8, C504a | Down | ||
| 7, C504a, and 5, C504b | |||
| Left rear window circuit | 8, C504b and 2, C504a | Up | Closed circuit |
| 1, C504a and 5, C504b | |||
| 8, C504b and 1, C504a | Down | ||
| 2, C504a and 5, C504b | |||
| Right rear window circuit | 8, C504b and 3, C504a | Up | Closed circuit |
| 4, C504a and 5, C405b | |||
| 8, C504b and 4, C504a | Down | ||
| 3, C504a and 5, C504b | |||
| Illumination | Connect pin 8, C504b to 12V DC power and pin 5, C504b to ground. | Visually inspect switch to verify illumination | |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
