2005 Ford Expedition RWDFACTORY OEM SERVICE PROCEDURE

Alignment Specifications

ALIGNMENT SPECIFICATIONS

Item LH RH Total/Split
Front Coil Spring Suspension 
Camber -0.3° +/- 0.75° -0.3° +/- 0.75° 0° +/- 0.75°
Caster 5.3° 1.0° 5.3° +/- 1.0° 0° +/- 0.75°
Toe @ curb ride height (positive value is toe-in, negative value is toe-out) - - 0.14° +/- 0.20°
Front Air Suspension 
Camber Navigator/Expedition -0.6°/-0.3° +/- 0.75° -0.6°/-0.3° +/- 0.75° 0° +/- 0.75°
Caster 5.5° +/- 1.0° 5.5° +/- 1.0° 0° +/- 0.75°
Toe @ trim ride height (positive value is toe-in, negative value is toe-out) - - -0.14° +/- 0.20°
Rear Coil Spring Suspension 
Camber -0.9° +/- 0.75° -0.9° +/- 0.75° 0° +/- 0.75°
Toe @ curb ride height (positive value is toe-in, negative value is toe-out) - - 0.20° +/- 0.20°
Rear Air Suspension 
Camber -1.0° +/- 0.75° -1.0° +/- 0.75° 0° +/- 0.75°
Toe @ trim ride height (positive value is toe-in, negative value is toe-out) - - -0.20° +/- 0.20°
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.