Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Ford Expedition 4WDFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft |
|---|---|---|
| Transmission fluid cooler tube bracket bolt at transmission | 48 | 35 |
| Transmission fluid cooler tube bracket bolt to front of engine | 25 | 18 |
| Transmission fluid cooler tubes-to-transmission bracket bolt (6HP26) | 23 | 17 |
| Transmission fluid cooler tubes-to-transmission (4R70E, 4R75E) | 20 | 15 |
| Transmission fluid cooler fittings in radiator | 60 | 44 |
| Transmission fluid cooler fittings-to-thermostatic valve | 20 | 15 |
| Sway bar bracket nuts | 55 | 41 |
| Axle housing bolt and nut | 102 | 75 |
| Auxiliary fluid cooler | 20 | 15 |
| Transaxle fill plug | 35 | 26 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
