2005 Ford Expedition 4WDFACTORY OEM SERVICE PROCEDURE

Engine Mechanical: Mechanical: Engine: Installation: Engine

SPECIAL TOOL DESCRIPTION

G03886715
Modular Engine Lift Bracket 303-F047 (014-00073) or equivalent
MATERIAL SPECIFICATIONS

Item Specification
Motorcraft SAE 5W-20 Premium Synthetic Blend Motor Oil XO-5W20-QSP (in Canada Motorcraft SAE 5W-20 Super Premium Motor Oil CXO-5W20-LSP12) or equivalent WSS-M2C930-A
Motorcraft Premium Gold Engine Coolant VC-7-A (in California, Oregon and New Mexico VC-7-B, in Canada CVC-7-A) or equivalent (yellow color) WSS-M97B51-A1

    All vehicles 

  1. Using a suitable floor crane, position the engine assembly into the vehicle.
  2. Remove the special tool.
    Fig 1: Removing Special Tool
    G03920205Courtesy of FORD MOTOR CO.
  3. CAUTION: Only use hand tools when installing the LH engine mount through bolt or damage to the cage nut can occur.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.