2005 Ford Excursion 6.8 S, 4WDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm lb-ft
Bolts retaining the OTA transmission fluid cooler to the frame 8 6
Bolts retaining the air deflector to the frame 15 11
Bolts retaining the skid plate to the frame (4x4 only) 15 11
Fluid cooler tube-to-in-tank fluid tube connector assembly (4R100) 27 20
Front cooler line case fitting-to-automatic transmission case (4R100) 30 22
Rear cooler line case fitting-to-automatic transmission case (4R100) 37 27
Fluid cooler tube-to-cooler line case fitting (4R100) 27 20
Fluid cooler inlet line-to-case (TorqShift) 40 30
Fluid cooler outlet line-to-case (TorqShift) 40 30
Fluid cooler line-to-cooler inlet (TorqShift) 40 30
Fluid cooler line-to-cooler outlet (TorqShift) 40 30
Remote mount filter bracket-to-frame (TorqShift) 25 18
Cooler line bracket nut-to-engine stud 10 7
Oil cooler tube-to-engine nut 8 6
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.