2005 Ford Excursion 5.4 L, RWDFACTORY OEM SERVICE PROCEDURE

Torque Specifications

TORQUE SPECIFICATIONS

Description Nm Lb-ft Lb-in
Exhaust manifold-to-Y-pipe studs 45 33 -
Exhaust manifold-to-Y-pipe nuts 40 30 -
Damper U-bolt nuts 40 30 -
Y-pipe-to-converter nuts 40 30 -
Heat shield nuts 20 15 -
Bracket and insulator nuts 20 15 -
Bracket and insulator bolt 47 35 -
Resonator inlet pipe clamp 58 43 -
Exhaust clamps (gasoline engine) 58 43 -
Exhaust clamps (6.0L diesel engine) 47 35 -
Turbocharger-to-downpipe clamp (diesel engines) 10 7 -
Exhaust downpipe-to-converter inlet nuts (6.0L diesel engine) 47 35 -
Transmission crossmember-to-frame bolts and nuts 81 60 -
Transmission fill tube bracket-to-engine nut (6.0L diesel engine) 12 9 -
EGR cooler clamp 6 - 53
Exhaust inlet pipe-to-exhaust manifold nuts 27 20 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.