2005 Ford Excursion 5.4 L, RWDFACTORY OEM SERVICE PROCEDURE

General Specifications

GENERAL SPECIFICATIONS

Item Specification
Brake Pads 
Brake pad minimum thickness 3.0 mm (0.118 inch)
Brake pad maximum thickness variation (pad-to-pad) 2.0 mm (0.079 inch)
Brake pad maximum taper wear (in any direction) 3.0 mm (0.118 inch)
Brake Disc 
Front brake disc minimum thickness 36.0 mm (1.41 inch)
Rear brake disc minimum thickness 28.0 mm (1.10 inch)
Minimum thickness to machine front brake disc 36.6 mm (1.44 inch)
Minimum thickness to machine rear brake disc 28.6 mm (1.12 inch)
Lubricant 
High Performance DOT 3 Motor Vehicle Brake Fluid PM-1 (Canada CPM-1) ESA-M6C25-A
High Temperature Nickel Anti-Seize Lubricant XL-2 ESE-M12A4-A
Silicone Brake Caliper Grease and Dielectric Compound XG-3-A ESE-M1C171-A
Brake Parts Cleaner PM-4 -
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.