Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Ford Excursion 5.4 L, 4WDFACTORY OEM SERVICE PROCEDURE
Alignment Specifications
ALIGNMENT SPECIFICATIONS
| Item | LH | RH | Total/Split |
|---|---|---|---|
| 4x2 | |||
| Camber | 0.62° +/- 1.0° | 0.62° +/- 1.0° | 0° +/- 1.0° |
| Caster | 4.4° +/- 1.4° | 4.6° +/- 1.4° | 0.2° +/- 0.75° |
| Toe @ curb ride height (positive value is toe-in, negative value is toe-out) | - | - | 0.1° +/- 0.25° |
| 4x4 | |||
| Camber | 0.25° +/- 1.0° | 0.25° +/- 1.0° | 0° +/- 1.0° |
| Caster | 3.63° +/- 2.0° | 4.0° +/- 2.0° | -0.37° +/- 0.55° |
| Toe @ curb ride height (positive value is toe-in, negative value is toe-out) | - | -- | 0.01° +/- 0.25° |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.