2004 Ford Mustang Mach 1, AutomaticFACTORY OEM SERVICE PROCEDURE

Control Units

CONTROL UNITS LOCATION

Component Location
ABS Control Module (Cobra) On right front of engine compartment, behind radiator. See Figure.
ABS Control Module (Mach 1) On right front of engine compartment, behind radiator. See Figure.
ABS Control Module (3.8L) On right front of engine compartment, behind radiator. See Figure.
ABS Control Module (4.6L 2V) On right front of engine compartment, behind radiator. See Figure.
Constant Control Relay Module (CCRM) (Mach 1) Inside right front fender, behind air filter housing. See Figure.
Constant Control Relay Module (CCRM) (3.8L) Inside right front fender, behind air filter housing. See Figure.
Constant Control Relay Module (CCRM) (4.6L 2V) Inside right front fender, behind air filter housing. See Figure.
Constant Control Relay Module (Cobra) Inside right front fender, behind air filter housing. See Figure.
Daytime Running Lamps (DRL) Module (Cobra) Left front corner of engine compartment. See Figure.
Daytime Running Lamps (DRL) Module (Mach 1) Left front corner of engine compartment. See Figure.
Daytime Running Lamps Module (3.8L) Left front corner of engine compartment. See Figure.
Daytime Running Lamps Module (4.6L 2V)) Left front corner of engine compartment. See Figure.
Fuel Pump Driver Module (Convertible) Underside of luggage compartment. See Figure.
Fuel Pump Driver Module (Coupe) Underside of luggage compartment. See Figure.
Generic Electronic Module (GEM) Below left side of dash. See Figure.
Inlet Manifold Runner Control (IMRC) Module (3.8L) At right rear of engine compartment. See Figure.
Passenger Air Bag Module At right side of dash. See Figure.
Passive Anti-Theft Transceiver Module On underside of steering column. See Figure.
Powertrain Control Module Behind right kick panel. See Figure.
Restraints Control Module Behind lower center of dash. See Figure.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.