Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Acceleration Control
The throttle is controlled by an accelerator cable attached to the accelerator pedal and shaft assembly. The accelerator pedal and shaft should travel smoothly from the idle position to the wide open throttle position. Hesitation or binding should not be experienced at any portion of the accelerator pedal and shaft travel. Surrounding components such as wiring, hoses, sound insulator and floor carpet must not contact the sliding inner member of the accelerator cable or interfere with the accelerator pedal and shaft.
The acceleration control consists of an accelerator pedal and cable.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.