Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE
System Specifications
Engine front cover bolts
Tighten the engine front cover fasteners in sequence in two stages.
^ Stage 1: Tighten fasteners 1 through 7 to 25 Nm (18 ft. lbs.).
^ Stage 2: Tighten fasteners 6 through 15 to 48 Nm (35 ft. lbs.).
Camshaft sprocket
Engines equipped with bolt-on sprockets
Install the camshaft sprocket (2).
Install the bolt (1).
Tighten the bolt.
^ M10 bolt: Tighten in two stages.
^ Stage 1: Tighten to 40 Nm (30 ft. lbs.).
^ Stage 2: Tighten an additional 90°.
^ M12 bolt: Tighten to 120 Nm (90 ft. lbs.).
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
