Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE
Body Control Module: Service and Repair
VEHICLE SECURITY MODULE
REMOVAL
CAUTION:
- Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
- Prior to the removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed.
1. Disconnect the battery.
2. Remove the lower center dash trim panel.

3. Disconnect the vehicle security module electrical connectors.

4. Remove the wiring harness retainer from the LH stud.

5. Remove the LH nut.

6. Remove the RH nut and the vehicle security module.
INSTALLATION
1. NOTE: Once the vehicle security module is installed it is necessary to download the module configuration information from the diagnostic tool into the new module.
To install, reverse the removal procedure.
REMOVAL
CAUTION:
- Electronic modules are sensitive to static electrical charges. If exposed to these charges, damage may result.
- Prior to the removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed.
1. Disconnect the battery.
2. Remove the lower center dash trim panel.
3. Disconnect the vehicle security module electrical connectors.
4. Remove the wiring harness retainer from the LH stud.
5. Remove the LH nut.
6. Remove the RH nut and the vehicle security module.
INSTALLATION
1. NOTE: Once the vehicle security module is installed it is necessary to download the module configuration information from the diagnostic tool into the new module.
To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
