Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE
Check Every Service (Multi-Point Inspection)
Multi-Point Inspection
- Check and top up fluid levels:
- brake
- coolant recovery reservoir
- manual and automatic transmission
- power steering
- window washer
- Inspect tires for wear and check air pressure. even spare
- Check exhaust system for leaks, damage, loose parts and foreign material
- Check battery performance
- Check operation of horn, exterior lamps, turn signals and hazard warning lights
- Check radiator, coolers, heater and air conditioning hoses.
- Inspect windshield washer spray and wiper operation
- Check windshield for crack, chips and pitting.
- Inspect for oil and fluid leaks
- Inspect air cleaner filter
- inspect half shaft dust boots, if equipped
- Check shocks and struts and other suspension components for leaks and damage
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
