Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE
Keyless Entry Key-Pad: Testing and Inspection
KEYLESS ENTRY KEYPAD CODE PROGRAMMING
Wireless Keyless Entry Keypad Remastering (F-Super Duty vehicles built before 12/03 only)
NOTE: Remastering can only be carried out once.
1. Enter the new master keycode into the new wireless keyless entry keypad.
2. Press and hold the 9/0 button for 2 seconds.
3. While holding the 9/0 button, press and hold the 5/6 button until the light on the unit flashes twice.
4. NOTE: If a mistake is made before the fifth number of the master keycode is entered, wait for 10 seconds and repeat Step 2.
Enter the old master keycode into the new wireless keyless entry keypad.
5. The door locks will cycle from unlock to lock then unlock to confirm that the master keycode has been changed.
6. Confirm that the master keycode has been changed in the new wireless keyless entry keypad by unlocking the vehicle with the master keycode.
Wireless Keyless Entry Keypad Remastering (F-Super Duty vehicles built before 12/03 only)
NOTE: Remastering can only be carried out once.
1. Enter the new master keycode into the new wireless keyless entry keypad.
2. Press and hold the 9/0 button for 2 seconds.
3. While holding the 9/0 button, press and hold the 5/6 button until the light on the unit flashes twice.
4. NOTE: If a mistake is made before the fifth number of the master keycode is entered, wait for 10 seconds and repeat Step 2.
Enter the old master keycode into the new wireless keyless entry keypad.
5. The door locks will cycle from unlock to lock then unlock to confirm that the master keycode has been changed.
6. Confirm that the master keycode has been changed in the new wireless keyless entry keypad by unlocking the vehicle with the master keycode.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
