Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Ford Excursion 2WD V10-6.8L VIN SFACTORY OEM SERVICE PROCEDURE
Keyless Entry Key-Pad: Service and Repair
KEYLESS ENTRY KEYPAD
REMOVAL
NOTE:
- This procedure applies to all Excursion and F-Super Duty vehicles built after 12/03.
- On F-Super Duty vehicles built before 12/03, the wireless keyless entry keypad uses a self-adhesive material to attach it to the driver door. No wiring harness disconnect is necessary.
1. Disconnect the battery.
2. Remove the front door trim panel.
3. Position the watershield aside.
4. Disconnect the keypad electrical connector.
- Release the harness pin-type retainers.

5. Remove the keyless entry keypad and harness.
1 Remove the clip.
2 Remove the keyless entry keypad and harness.
INSTALLATION
1. To install, reverse the removal procedure.
REMOVAL
NOTE:
- This procedure applies to all Excursion and F-Super Duty vehicles built after 12/03.
- On F-Super Duty vehicles built before 12/03, the wireless keyless entry keypad uses a self-adhesive material to attach it to the driver door. No wiring harness disconnect is necessary.
1. Disconnect the battery.
2. Remove the front door trim panel.
3. Position the watershield aside.
4. Disconnect the keypad electrical connector.
- Release the harness pin-type retainers.
5. Remove the keyless entry keypad and harness.
1 Remove the clip.
2 Remove the keyless entry keypad and harness.
INSTALLATION
1. To install, reverse the removal procedure.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
