Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Ford Escape 2.0 BFACTORY OEM SERVICE PROCEDURE
Torque Specifications
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Camshaft position sensor bolt-2.0L (Zetec) | 20 | 15 | - |
| Camshaft position sensor bolt-3.0L (4V) | 10 | - | 89 |
| Catalyst monitor sensor | 40 | 30 | - |
| Clutch pedal position switch nut | 16 | 12 | - |
| Crankshaft position sensor bolt-2.0L Zetec | 7 | - | 62 |
| Crankshaft position sensor bolt-3.0L (4V) | 10 | - | 89 |
| Cylinder head temperature sensor-2.0L Zetec | 10 | - | 89 |
| Engine coolant temperature sensor-3.0L (4V) | 12 | 9 | - |
| Heated oxygen sensor | 40 | 30 | - |
| Idle air control valve bolts | 10 | - | 89 |
| Knock sensor-2.0L Zetec | 20 | 15 | - |
| Power steering pressure switch | 10 | - | 89 |
| Powertrain control module harness bolt | 6 | - | 53 |
| Powertrain control module cover nuts | 6 | - | 53 |
| Splash shield bolts | 9 | - | 80 |
| Throttle position sensor screws-3.0L (4V) | 3 | - | 27 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.