Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Ford Escape 2.0 BFACTORY OEM SERVICE PROCEDURE
Control Units
CONTROL UNITS LOCATION
| Component | Location |
|---|---|
| ABS Control Module | On left rear side of engine compartment. See Figure . |
| Daytime Running Lamps Module | Behind lower left end of dash. See Figure . |
| Driver Air Bag Unit | On steering wheel. See Figure . |
| Electronic Flasher Module | Behind lower left end of dash. See Figure . |
| Generic Electronic Module (GEM) | Behind lower center of dash. See Figure . |
| Heated Seat Module (Driver Side Front) | Under driver's seat. See Figure . |
| Heated Seat Module (Passenger Side Front) | Under passenger's seat. See Figure . |
| Parking Aid Module (PAM) | At right rear side of vehicle floor. See Figure . |
| Passenger Air Bag Module | On right side of dash. See Figure . |
| Passive Anti-Theft Transceiver | Behind lower left side of dash, near steering column. See Figure . |
| Powertrain Control Module (PCM) | In recess on upper center of firewall. See Figure . |
| Restraints Control Module | Beneath lower center of dash, on transmission tunnel. See Figure . |
| Roof Opening Panel Module | At center front of roof. See Figure . |
| Side Air Bag Module (Left) | On left front floor. See Figure . |
| Side Air Bag Module (Right) | On right front floor. See Figure . |
| Transmission Hardware Unit | Left side of transmission. See Figure . |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
