Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE
Torque Specifications
WARNING: This page is about a different variant/trim than selected.
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft | lb-in |
|---|---|---|---|
| Gearshift Lever Knob Screw | 2.0 - 2.9 | - | 18 - 26 |
| Gearshift Lever Cable Nut | 7.9 - 10.7 | - | 70 - 95 |
| Cable Floorpan Bracket Bolt | 7.9 - 10.7 | - | 70 - 95 |
| Transmission Control Selector Dial Bezel Screw | 2.0 - 2.9 | - | 18 - 26 |
| Brake Shift Interlock Actuator Screw | 1.3 - 1.8 | - | 12 - 16 |
| Cable Bulkhead Bracket Nut | 7.9 - 10.7 | - | 70 - 95 |
| Transmission Range Switch Cable Nut | 16 - 22 | 12 - 16 | - |
| Ignition/Shifter Interlock Cable Locknut | 9.4 - 14.0 | - | 87 - 130 |
| Gearshift Lever Nut | 16 - 22 | 12 - 16 | - |
| Ignition/Shifter Interlock Cable Bracket Nut | 4.3 - 6.1 | - | 38 - 54 |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.