2003 Ford ZX2 StandardFACTORY OEM SERVICE PROCEDURE

Items 7-20: Timing Drive Components Removal Note

WARNING: This page is about a different car, the 2003 Lincoln LS. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the crankshaft position (CKP) sensor and the torque converter cover.
    Fig 1: Removing Crankshaft Position (CKP) Sensor And Torque Converter Cover
    G01286119Courtesy of FORD MOTOR CO.
  2. NOTE: There is one window on the ignition pulse wheel that is unique to accept the special tool.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.